The smallest mark on a tape measure is:

What is the first thing to do at the jobsite?

What type of hammer is commonly selected for trim work?

What are plywood clips used for?

In a mixed system (floor & wall mount) which section should be installed first?

What is the correct heights of installed shelves on double hang?

Calculate 1/4 inch plus 1/4 inch.

What is the last thing that needs to be done upon completion of installation, before walk-thru with the client?

The path a saw blade cuts in a piece of wood is called:

When squaring up a large rectangle object, which method would be the least acceptable to use?

What is the standard height for a long hanging section?

In a 75” reach-in closet with bi-fold doors divided into three section, where is the best position to place drawers?

When installing a wire shelf wall-to-wall, what deduction in width must be taken to allow for end-brackets?

What is the best way to clean thermofoil (3DL) doors/drawers?

Subtract 3 15/32 inches from 9 1/16 inches

1/4” or .25 converts into millimeters as…

Which number is greatest?

What screw, or screws adjust the hinge overlay?

A lot measures 112 feet and 5 inches x 88 feet and 3 inches x 97 feet and 6 inches x 114 feet and 2 inches. What is the distance around the lot?

What is the perimeter of a square with sides 9 feet and 6 inches long?

Which is greater in inches?

What is the best practice to adhere to when there is a question or an issue with the design if designed by a designer?

When using a circular saw, the best way to prevent kickback is to keep the blade sharp.

With 3/4” vertical dividers, what is the maximum number of storage spaces with exactly 7 1/2” will fit in a unit with 24” wide shelves?